*** Under Construction ***

My latest project is a 7.5 inch PML Pterodactyl that I am adding a 3 ft section to the front for dual deployment recovery. In addition, I am adding 3 outboard 38mm motor mounts to the standard central 54mm mount for air-starting. I will update this page as I make more progress.

Rear view of rocket showing motor mount configuration	Assembled fin can- body tube was slotted to allow entire assembly to be installed after construction
Another view of fin can- top centering ring will be installed after installation into airframe	Close-up showing brass tubing used to run igniters from air start timer to outboard motors
Timer bay door in airframe	Timer bay door opening- pem nuts were installed in coupler section for ease of door removal
Timer board test fit into mount	Timer board is removable through access door